Polish and Repair
Due to the high quality and ultra-durable autoclave finish, our products are extremely resistant to chips or scratches. Accidents do happen however with all those tiny little rocks and dust. Sometimes the clear coat might need a little care to bring it back to its original pristine finish.
We recommend the following products to give you the best looking finish for your carbon fiber.
Check back soon too for videos and tutorials and How-To's!
Deep Pitting and Cracks:
Any deep pitting and cracks can be fixed using Krazy Glue ® Super Glue. The epoxy clear coat used in all of our products has the same refraction index as Super Glue, making repairs to cracks and pits as easy as a few drops of super glue following by wet sanding and polishing until a flawless finish is achieved.
Polishing and scratch repair:
Using our custom tested 5-Step process, you can fix most small cracks and scratches.
Here is our 5-Step process to repair your carbon fiber:
Step 1. For deep scratches, sand the area using 400 then 800 >1000>1500>2000 grit sand paper until most visible sand paper scratches disappear. We recommend wet sanding past 1000 grit to achieve a more uniform finish.
Step 2. Follow up with a thorough application of TURTLE WAX® Polishing Compound using an applicator pad or a microfiber towel until all the visible markings from the sand paper are gone. Make sure to wipe away, or even wash and dry the area to eliminate all residue before proceeding to step 3.
Step 3. Using a microfiber towel or a powered buffer, apply Meguiar's : Ultimate Compound. Make sure to wipe away, or even wash and dry the area to eliminate all residue before proceeding to step 4.
Step 4. Similar to the procedure in Step 3, use a microfiber towel or a powered buffer to apply Meguiar's : Ultimate Polish. Make sure to wipe away (wash and dry is recommended) the area to eliminate all residue before proceeding to step 5.
Step 5. Using a microfiber towel or applicator pad, apply a thin, even coat of Smartwax® - Evolution In Car Care TM. Wait until the wax sets and becomes matte. Using a clean microfiber towel, wipe in circular motion until all residue is removed and your carbon fiber part shines again like new!
Let us know if you have any other questions or concerns and we will do our best to help you out!